how to load preset banks in albino 3?

  • Thread starter Thread starter feelhim
  • Start date Start date
F

feelhim

New member
I have albino 3 and im using it in fl studio.I downloaded some soundbanks for it and i'm trying to figure out how to import them all at once instead of sound by sound because there are a lot of them.thanks in advance
 
around the same area where you change sounds there are two arrows, and a S, and a L..... L is for load. After you do that the presets will show up in your sound browser(for that one instance).
 
Last edited by a moderator:
breal said:
Banks file names end in fxb
Preset file names end in fxp
Click to expand...

they're presets then.How do I load them into albino.thanks again
 
We just told you ...
 
Last edited by a moderator:
bump! how the hell do i do this? i got a **** load or presets for albino and cant figure out were to put them or how to load them??

using fl8

thanks
 
you need to put them in the banks folder .. like find your Albino 3 folder..where you install your vsti's too..so plugins>Vsti if your using FL.. mines named Rob Papen, open that and you should find a Albino3Banks..drag and drop the banks of your choice (make sure they're un-rar'd if you need to extract them)..load up albino 3 fresh and you should find the banks in the bottom right corner where you select your presets usually..
 
I don't underatand either. Brand new to beatmaking and Albino. I have loads of sounds, but when I browse amd select one, nothing changes.
 
where the master sound is there is a S snd A L button just click on that and load the first preset in your folder and Albino will load the whole pack
 
You must log in or register to reply here.
Back
Top